Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > TERMINALS OF ECU

for Preparation Click here



CHECK TELEVISION CAMERA ASSEMBLY

E177910E01

  1. Disconnect the X1 television camera assembly connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    X1-4 (CGND) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    X1-3 (CB+) - X1-4 (CGND)
    B - W
    Power source
    Ignition switch ON, shift lever R position
    5.5 to 7.05 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the X1 television camera assembly connector.

  4. Measure the waveform according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    X1-1 (CV+) - X1-2 (CV-)
    R - L
    Television camera image signal
    Ignition switch ON, shift lever in R
    Pulse generation (refer to waveform 1)
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens
    Pulse generation (refer to waveform 2)
    If the result is not as specified, the television camera assembly may have a malfunction.



  5. E171712E24
  6. Using an oscilloscope, check the waveform.

    1. Waveform 1
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      X1-1 (CV+) - X1-2 (CV-)
      Tool Setting
      0.2 V/DIV., 50 μs/DIV.
      Condition
      Ignition switch ON, shift lever in R

      HINT:
      The video waveform changes according to the image sent by the television camera assembly.

    2. Waveform 2
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      X1-1 (CV+) - X1-2 (CV-)
      Tool Setting
      0.2 V/DIV., 50 μs/DIV.
      Condition
      Ignition switch ON, shift lever in R, screen blacked out by covering camera lens

      HINT:
      The video waveform changes according to the image sent by the television camera assembly.

      Text in Illustration 
      *a
      Waveform 1
      *b
      Waveform 2
      *c
      Synchronized Signal
      *d
      Video Waveform


CHECK NAVIGATION RECEIVER ASSEMBLY (for SD Navigation System) (Click here)

CHECK NAVIGATION RECEIVER ASSEMBLY (for DVD Navigation System) (Click here)