AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the K4 radio receiver assembly connector.
Disconnect the K15 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K4-9 (L+) - K15-3 (L+) | Always | Below 1 Ω |
| K4-19 (L-) - K15-2 (L-) | Always | Below 1 Ω |
| K4-8 (R+) - K15-5 (R+) | Always | Below 1 Ω |
| K4-18 (R-) - K15-4 (R-) | Always | Below 1 Ω |
| K4-10 (SLD) - K15-6 (SLD) | Always | Below 1 Ω |
| K4-9 (L+) - Body ground | Always | 10 kΩ or higher |
| K4-19 (L-) - Body ground | Always | 10 kΩ or higher |
| K4-8 (R+) - Body ground | Always | 10 kΩ or higher |
| K4-18 (R-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||