Home › DRIVE LINE › DIFFERENTIAL › FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD)

FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEELS


2. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



3. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. for Front Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 398 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and drain the oil.

    3. Install a new gasket and the drain plug.

      Torque:
      49 N*m{ 500 kgf*cm , 36 ft.*lbf }



4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
  1. Remove the front propeller shaft (Click here).



5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
  1. Remove the front drive shaft (Click here).



6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedure as the LH side.



7. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY


    C159283E01
  1. Remove the bolt and disconnect the front differential breather tube bracket.

  1. Disconnect the automatic disconnecting differential actuator hose.

  1. Disconnect the automatic disconnecting differential actuator connector.

  1. Support the front differential with a jack.

  1. Remove the A, B, C, D and E bolts.

  1. Slowly lower the jack, and remove the front differential carrier.

  1. Remove the F and G bolts, and differential support.