Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source for the tire pressure warning ECU.

WIRING DIAGRAM


C230141E02


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or tire pressure warning valve and transmitter has been replaced.

1.INSPECT FUSE (ECU-IG No.1)
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND)
  1. Disconnect the J31 ECU connector.



    C151036E05
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J31-7 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J31-9 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)  

3.CHECK HARNESS AND CONNECTOR (ECU - BATTERY)
  1. Disconnect the J31 ECU connector.



    C151036E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J31-7 (IG) - Body ground
    Always
    10 kΩ or higher



NG
REPLACE FUSE AND REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FUSE