GENERATOR > INSTALLATION |
| 1. INSTALL GENERATOR ASSEMBLY |
Install the generator bracket to the generator with the bolt.
Install the generator with the 2 bolts.
Install the generator bracket with the bolt.
Attach the wire harness clamp.
Connect the wire harness bracket with the bolt.
Connect the generator connector to the generator.
Install the generator wire with the nut.
Close the terminal cap.
| 2. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR |
Install the heat insulator with the 3 bolts.
| 3. INSTALL FRONT FENDER APRON SEAL REAR LH |
Install the fender apron seal with the 5 clips.
| 4. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY |
for Integrated Type:
Install the No. 2 idler pulley with the bolt.
for Separate Type:
Install the idler pulley cover plate, No. 2 idler pulley and No. 2 idler pulley cover plate with the bolt.
| 5. INSTALL FAN AND GENERATOR V BELT |
![]() |
Set the V belt onto every part.
| *1 | Vane Pump |
| *2 | Water Pump |
| *3 | No. 2 Idler |
| *4 | Generator |
| *5 | Cooler Compressor |
| *6 | No. 1 Idler |
| *7 | Crankshaft |
| *8 | V-ribbed Belt Tensioner |
While turning the belt tensioner counterclockwise, remove the pin.
![]() |
Check that the belt fits properly in the ribbed grooves.
| *1 | CORRECT |
| *2 | INCORRECT |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |