Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1360/61    Malfunction in Comparative Master Cylinder Pressure Sensor

DTC    C1281/81    Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The master cylinder pressure sensor is built into the VSC actuator.

DTC Code
DTC Detection Condition
Trouble Area
C1360/61
When any of the following conditions are detected:
  1. When malfunction occurs during pressure sensor initial check.
  2. When signal value is out of range.
  3. When zero point calibration value is out of range.
  1. Master cylinder pressure sensor
  2. Master cylinder pressure sensor circuit
C1281/81
Detected only during test mode.
  1. Master cylinder pressure sensor
  2. Master cylinder pressure sensor circuit
  3. Stop light switch circuit
  4. Skid control ECU
  5. Brake booster assembly

INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform the zero point calibration (Click here).

1.CHECK BRAKE PEDAL
  1. Check if the brake pedal is spongy.

    OK:
    The brake pedal is normal.



NG
BLEED AIR (Click here)
OK


2.PERFORM TEST MODE PROCEDURE (MASTER CYLINDER PRESSURE SENSOR)
  1. Perform the test mode procedure (Click here).

  1. Check if the test mode procedure (master cylinder pressure sensor) is finished successfully.

    Result 
    Result
    Proceed to
    The test mode procedure (master cylinder pressure sensor) is not finished successfully
    A
    The test mode procedure (master cylinder pressure sensor) is finished successfully
    B



B
REPLACE VSC ACTUATOR ASSEMBLY (Click here)
A


3.INSPECT BRAKE BOOSTER ASSEMBLY
  1. Inspect the brake booster (Click here).



NG
REPLACE BRAKE BOOSTER ASSEMBLY (Click here)
OK


4.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and check if the same DTC is stored in the memory (Click here).
    Result: 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)