Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CRANK ENGINE FOR MORE THAN 10 SECONDS

      NEXT


      4.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs. Try to duplicate the DTC (SFI system and engine immobiliser system) by simulating the symptoms indicated by the DTC.
        Result 
        Result
        Proceed to
        DTC is not output
        A
        SFI system (for 1UR-FE) DTC is output
        B
        SFI system (for 3UR-FE) DTC is output
        C
        SFI system (for 3UR-FBE) DTC is output
        D
        Engine immobiliser system DTC is output
        E



      B.
      Go to SFI SYSTEM (Click here)

      C.
      Go to SFI SYSTEM (Click here)

      D.
      Go to SFI SYSTEM (Click here)

      E.
      Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
      A


      5.PROBLEM SYMPTOMS TABLE
        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List/Active Test (Click here)

      2. Terminals of ECU (Click here)


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END