AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |


| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER) |
w/o USB Audio System:
![]() |
Disconnect the K3 radio receiver assembly connector.
Disconnect the J7 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K3-17 (ALI) - J7-1 (ALO) | Always | Below 1 Ω |
| K3-15 (ARI) - J7-2 (ARO) | Always | Below 1 Ω |
| K3-16 (ASGN) - J7-3 (ASGN) | Always | Below 1 Ω |
| K3-18 (AGND) - J7-5 (AUXG) | Always | Below 1 Ω |
| K3-19 (AUXI) - J7-4 (AUXO) | Always | Below 1 Ω |
| K3-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| K3-15 (ARI) - Body ground | Always | 10 kΩ or higher |
| K3-16 (ASGN) - Body ground | Always | 10 kΩ or higher |
| K3-19 (AUXI) - Body ground | Always | 10 kΩ or higher |
w/ USB Audio System:
![]() |
Disconnect the K3 radio receiver assembly connector.
Disconnect the J7 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K3-17 (ALI) - J100-6 (ALO) | Always | Below 1 Ω |
| K3-15 (ARI) - J100-5 (ARO) | Always | Below 1 Ω |
| K3-16 (ASGN) - J100-7 (ASGN) | Always | Below 1 Ω |
| K3-18 (AGND) - J100-9 (AGND) | Always | Below 1 Ω |
| K3-19 (AUXI) - J100-8 (AUXO) | Always | Below 1 Ω |
| K3-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| K3-15 (ARI) - Body ground | Always | 10 kΩ or higher |
| K3-16 (ASGN) - Body ground | Always | 10 kΩ or higher |
| K3-19 (AUXI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||