Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1336/39    Zero Point Calibration of Acceleration Sensor Undone

for Preparation Click here


DESCRIPTION

A new skid control ECU is supplied without zero point calibration for the deceleration sensor and master cylinder pressure sensor. Until the zero points are calibrated, DTC C1336/39 remains stored. By entering test mode, the zero point calibration is automatically performed, and DTC C1336/39 is erased automatically.

DTC Code
DTC Detection Condition
Trouble Area
C1336/39
When the vehicle is driven without completion of zero point calibration.
  1. Skid control ECU
  2. Zero point calibration incomplete

INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform the zero point calibration (Click here).

HINT:
When U0123/62, U0124/69 or U0126/63 is output together with C1336/39, inspect and repair trouble areas indicated by U0123/62, U0124/69 or U0126/63 first.

1.CHECK SENSOR USING TEST MODE PROCEDURE
  1. Perform the test mode procedure (Click here).

  1. Check if any of the test mode DTCs are recorded.
    Result 
    Result
    Proceed to
    DTC (test mode DTC) is not output
    A
    DTC (test mode DTC) is output
    B



B
REPAIR SENSORS INDICATED BY OUTPUT DTCS (Click here)
A


2.CHECK YAW RATE SENSOR INSTALLATION
  1. Check that the yaw rate sensor has been installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not tilted.



NG
INSTALL YAW RATE SENSOR CORRECTLY
OK


3.PERFORM DECELERATION SENSOR ZERO POINT CALIBRATION
  1. Perform zero point calibration of the deceleration sensor (Click here).


NEXT


4.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Check if the same DTC is recorded (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    1. The DTC is set if the zero point calibration has not been completed successfully.
    2. End the procedure when the same DTC is not set after completion of the zero point calibration.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)