AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Multi-media Interface ECU and Television Display Assembly |

| 1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - TELEVISION DISPLAY) |
![]() |
Disconnect the J108 multi-media interface ECU connector.
Disconnect the W2 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J108-7 (ULI+) - W2-30 (L+) | Always | Below 1 Ω |
| J108-15 (ULI-) - W2-31 (L-) | Always | Below 1 Ω |
| J108-8 (URI+) - W2-28 (R+) | Always | Below 1 Ω |
| J108-16 (URI-) - W2-29 (R-) | Always | Below 1 Ω |
| J108-7 (ULI+) - Body ground | Always | 10 kΩ or higher |
| J108-15 (ULI-) - Body ground | Always | 10 kΩ or higher |
| J108-8 (URI+) - Body ground | Always | 10 kΩ or higher |
| J108-16 (URI-) - Body ground | Always | 10 kΩ or higher |
| W2-27 (SLD9) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||