Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a DVD image signal from the television display assembly to the navigation receiver assembly.

WIRING DIAGRAM


E190588E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION DISPLAY)


    E191673E05
  1. Disconnect the K24 navigation receiver assembly connector.

  1. Disconnect the W2 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K24-2 (VV+) - W2-11 (NTSO)
    Always
    Below 1 Ω
    K24-6 (VV-) - W2-10 (SGN1)
    Always
    Below 1 Ω
    K24-2 (VV+) - Body ground
    Always
    10 kΩ or higher
    K24-6 (VV-) - Body ground
    Always
    10 kΩ or higher
    W2-9 (SLD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TELEVISION DISPLAY ASSEMBLY


    E153728E13
  1. Reconnect the W2 television display assembly connector.

  1. Measure the waveform according to the table below.

    OK:
    Tester Connection
    Condition
    Specified Condition
    W2-11 (NTSO) - Body ground
    DVD display is on
    A waveform synchronized with display signals is output

    HINT:
    The waveform pattern may differ from that shown in the illustration below due to differences in the oscilloscope setting. A normal television display assembly operating condition can be determined if any waveform is output.



    E159949E01
  1. Using an oscilloscope, check waveform.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    W2-11 (NTSO) - Body ground
    Tool Setting
    0.2 V/DIV., 50 μsec./DIV.
    Condition
    DVD display is ON

    NOTICE:
    The video waveform changes according to the image output from television display assembly to navigation receiver assembly, but the synchronization signal does not change.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)