Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2176/76    Receiver Error

for Preparation Click here


DESCRIPTION

The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.

DTC Code
DTC Detection Condition
Trouble Area
C2176/76
Malfunction in the tire pressure warning ECU internal circuit.
Tire pressure warning ECU

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

1.CLEAR DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.


NEXT


2.CHECK DTC
  1. Check for DTC.
    Result 
    Result
    Proceed to
    DTC C2176 is output
    A
    DTC C2176 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE TIRE PRESSURE WARNING ECU (Click here)