POWER STEERING SYSTEM (for 1UR-FE) > DTC CHECK / CLEAR |
| CHECK DTC |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / PPS / Trouble codes.
Read the DTCs by following the display on the Techstream.
Refer to Diagnostic Trouble Code Chart for DTC information (Click here).
| CLEAR DTC |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / PPS / Trouble codes.
Clear the DTCs by following the display on the Techstream.
Turn the ignition switch off.
Disconnect the Techstream from the DLC3.