Home › STEERING › POWER STEERING › POWER STEERING SYSTEM (for 1UR-FE)

POWER STEERING SYSTEM (for 1UR-FE) > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


 
DTC Code
Detection Item
Trouble Area
Return-to-normal
See page
C1231
Lost Communication with Steering Angle Sensor Module
- Steering angle sensor (Spiral cable sub-assembly)
- CAN communication system
- Power steering ECU assembly
After normal confirmation
Click here
C1531
ECU Malfunction
- Harness or connector
- Vane pump assembly
- Power steering ECU assembly
Ignition switch turned to ON again
Click here
C1544
High Engine Revolution Signal
- Engine control system
- CAN communication system
- Power steering ECU assembly
After normal confirmation
Click here
C1547
Vehicle Speed Sensor
- Speed sensor circuit
- Brake control system
- CAN communication system
- Power steering ECU assembly
After normal confirmation
Click here
U0073
Control Module Communication Bus Off
- Steering angle sensor (Spiral cable sub-assembly)
- Engine control system
- Brake control system
- CAN communication system
- Power steering ECU assembly
After CAN communication system returns to normal condition or ignition switch turned to ON again
Click here