Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE GENERATOR ASSEMBLY
(Click here)


2. DISCONNECT COOLER COMPRESSOR ASSEMBLY
  1. Disconnect the cooler compressor connector.



    A238276
  1. Remove the 2 bolts, 2 nuts and 2 stud bolts and disconnect the cooler compressor.

    HINT:
    It is not necessary to completely remove the compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.



3. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



4. REMOVE CRANKSHAFT POSITION SENSOR


    A076417
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.