Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Standard cold tire inflation pressure:  
    Tire size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P255/70R18
    210 (2.1, 30)
    230 (2.3, 33)
    P275/65R18
    P275/55R20
    P255/70R18 (Spare Tire)
    230 (2.3, 33)



    R003031
  1. Using a dial indicator, check the tire runout.

    Tire runout:
    3.0 mm (0.118 in.) or less



2. ROTATE TIRE


    C258067E01
  1. Rotate the tires as shown in the illustration.

    Torque:
    for Aluminum Wheel:
    131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
    for Steel Wheel:
    209 N*m{ 2131 kgf*cm , 154 ft.*lbf }

    Text in Illustration 
    *a
    Front of the Vehicle



3. INSPECT WHEEL BALANCE


  1. for Steel Wheel Type:
    Check and adjust the off-the-car balance.

    Standard Imbalance After Adjustment:
    8.0 g (0.0180 lb) or less



    C270573E01


    Text in Illustration 
    *a
    except Chrome Type Wheel
    *b
    for Chrome Type Wheel

    NOTICE:
    1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be attached.
    2. Do not touch the adhesive surface of the tape.
    3. Attach a sticking-type balance weight to the flat surface (A) shown in the illustration.

      Width (A):
      25 mm (0.984 in.)

    4. Push the balance weight firmly so that it securely adheres to the position.
    5. Do not reuse the balance weight.

    HINT:
    1. For chrome type wheels, the inner side balance weight should be installed by clipping it to the rim.
    2. If necessary, check and adjust the on-the-car balance.



    C221195E01
  1. for Aluminum Wheel Type:
    Check and adjust the off-the-car balance.

    Standard Imbalance After Adjustment:
    8.0 g (0.0180 lb) or less

    NOTICE:
    1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
    2. Do not touch the sticking surface of the tape.
    3. Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

      Width (A):
      25 mm (0.984 in.)

    4. Push the balance weight firmly to adhere it to the position.
    5. Do not reuse the balance weight.

    HINT:
    If necessary, check and adjust the on-the-car balance.



4. INSPECT FRONT AXLE HUB
(Click here)


5. INSPECT REAR AXLE SHAFT
(Click here)