Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR ASSEMBLY
(Click here)


2. DISCONNECT WATER BY-PASS PIPE SUB-ASSEMBLY


    A225377
  1. Remove the 3 bolts.



    A222108
  1. Disconnect the 2 hoses and water by-pass pipe.



3. REMOVE OIL FILTER BRACKET


    A225410
  1. Remove the 2 nuts, bolt, oil filter bracket and gasket.



4. REMOVE CRANKSHAFT PULLEY


    A072947E04
  1. Using SST, hold the crankshaft pulley and loosen the pulley bolt. Continue to loosen the bolt until only 2 or 3 threads are screwed into the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A072948E02
  1. Using the pulley set bolt and SST, remove the crankshaft pulley and pulley bolt.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05031)



5. REMOVE FRONT CRANKSHAFT OIL SEAL


    A221099
  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or crankshaft.