INTUITIVE PARKING ASSIST SYSTEM > Rear Clearance Sonar Sensor RH Circuit |

| 1.REPLACE REAR CORNER NO. 1 ULTRASONIC SENSOR RH |
Replace the ultrasonic sensor with a normally functioning sensor (Click here).
| NEXT | |
| 2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - ECU) |
![]() |
Disconnect the S2 ultrasonic sensor connector.
Disconnect the J35 clearance warning ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S2-1 (BI) - J35-24 (BOR) | Always | Below 1 Ω |
| S2-3 (SI) - J35-6 (SOR) | Always | Below 1 Ω |
| S2-5 (EI) - J35-22 (E2) | Always | Below 1 Ω |
| S2-1 (BI) - Body ground | Always | 10 kΩ or higher |
| S2-3 (SI) - Body ground | Always | 10 kΩ or higher |
| S2-5 (EI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||