Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Back Sonar Sensor LH Circuit

for Preparation Click here


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM


E132021E22


INSPECTION PROCEDURE

1.REPLACE BACK NO. 2 ULTRASONIC SENSOR LH
  1. Replace the ultrasonic sensor with a normally functioning sensor (Click here).


NEXT


2.CHECK HARNESS AND CONNECTOR (BACK SENSOR LH - BACK SENSOR RH)
B144572E28
  1. Disconnect the S4 and S3 ultrasonic sensor connectors.

  1. Measure the Resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Condition
    Condition
    Specified Condition
    S4-1 (BI) - S3-2 (BO)
    Always
    Below 1 Ω
    S4-3 (SI) - S3-4 (SO)
    Always
    Below 1 Ω
    S4-5 (EI) - S3-6 (EO)
    Always
    Below 1 Ω
    S4-1 (BI) - Body ground
    Always
    10 kΩ or higher
    S4-3 (SI) - Body ground
    Always
    10 kΩ or higher
    S4-5 (EI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)