Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the radio receiver assembly.
It also supplies power from the radio receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E177208E07


INSPECTION PROCEDURE

1.CHECK RADIO RECEIVER ASSEMBLY


    E195982E09
  1. Disconnect the K25 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K25-5 (MIC-) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K25-3 (MACC) - Body ground
    Ignition switch ACC
    4.75 to 5.25 V

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO RECEIVER ASSEMBLY (Click here)

C
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
A


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - ROOF CONSOLE BOX)


    E190371E03
  1. Disconnect the K25 radio receiver assembly connector.

  1. Disconnect the W7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K25-3 (MACC) - W7-10 (ACC)
    Always
    Below 1 Ω
    K25-2 (MIC+) - W7-9 (MIC+)
    Always
    Below 1 Ω
    K25-5 (MIC-) - W7-8 (MIC-)
    Always
    Below 1 Ω
    K25-1 (SNS2) - W7-14 (SGND)
    Always
    Below 1 Ω
    K25-3 (MACC) - Body ground
    Always
    10 kΩ or higher
    K25-2 (MIC+) - Body ground
    Always
    10 kΩ or higher
    K25-5 (MIC-) - Body ground
    Always
    10 kΩ or higher
    K25-1 (SNS2) - Body ground
    Always
    10 kΩ or higher
    K25-6 (SGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the telephone microphone assembly with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Short Type)
    B
    NG (for Long Type)
    C



B
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)

C
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
A

END (TELEPHONE MICROPHONE IS FAULTY)