Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY


    F051260E01
  1. Install the vane pump with the 2 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

  1. Connect the wire harness clamp.



2. CONNECT PRESSURE FEED TUBE


C158817E01
  1. Install a new gasket to the pressure feed tube.

  1. Install the pressure feed tube with the union bolt.

    Torque:
    51 N*m{ 520 kgf*cm , 38 ft.*lbf }



3. CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


C158739
  1. Connect the power steering oil pressure switch connector.



4. CONNECT SUCTION HOSE


    C158815E01
  1. Connect the suction hose with the clip.



5. INSTALL FAN AND GENERATOR V BELT


    A225650E01
  1. Set the V belt onto every part.
    Text in Illustration 
    *1
    Vane Pump
    *2
    Water Pump
    *3
    No. 2 Idler
    *4
    Generator
    *5
    Cooler Compressor
    *6
    No. 1 Idler
    *7
    Crankshaft
    *8
    V-ribbed Belt Tensioner

  1. While turning the belt tensioner counterclockwise, remove the pin.

    NOTICE:
    Make sure that the V belt is properly installed to each pulley.



    B000540E06
  1. Check that the belt fits properly in the ribbed grooves.
    Text in Illustration 
    *1
    CORRECT
    *2
    INCORRECT

    HINT:
    Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.



6. ADD POWER STEERING FLUID


7. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

  1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)

    2. Repeat (*1) several times.

  1. Stop the engine.



    C124274E02
  1. Check for foaming or emulsification.
    If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

  1. Check the fluid level.



8. INSPECT FOR POWER STEERING FLUID LEAK


9. INSTALL NO. 1 ENGINE UNDER COVER


    A150108
  1. Hook the engine under cover to the vehicle body as shown in the illustration.

  1. Install the 3 screws and 5 bolts.

    Torque:
    for bolt:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }
    for screw:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).