VANE PUMP (for 3UR-FE, 3UR-FBE) > INSTALLATION |
| 1. INSTALL VANE PUMP ASSEMBLY |
![]() |
![]() |
Install the vane pump with the 2 bolts.
| 2. CONNECT PRESSURE FEED TUBE |
![]() |
Install a new gasket to the pressure feed tube.
Install the pressure feed tube with the union bolt.
| 3. CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR |
![]() |
Connect power steering oil pressure sensor connector.
| 4. CONNECT NO.1 OIL RESERVOIR TO PUMP HOSE |
![]() |
Connect the pump hose with the clip.
| 5. CONNECT WIRE HARNESS CLAMP |
![]() |
Connect the wire harness clamp.
| 6. INSTALL FAN AND GENERATOR V BELT |
![]() |
Set the V belt onto every part.
While turning the belt tensioner counterclockwise, remove the pin.
![]() |
After installing the belt, check that it fits properly in the ribbed grooves.
| 7. INSTALL AIR CLEANER ASSEMBLY |
![]() |
Install the air cleaner case with the 2 bolts.
Install the air cleaner element onto the air cleaner case.
![]() |
Install the air cleaner cap.
Fasten the 4 hook clamps.
Connect the MAF meter connector.
Attach the wire harness clamp.
| 8. INSTALL V-BANK COVER SUB-ASSEMBLY |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.
| 9. ADD POWER STEERING FLUID |
| 10. BLEED POWER STEERING FLUID |
Check the fluid level.
Jack up the front of the vehicle and support it with stands.
Turn the steering wheel.
With the engine stopped, turn the wheel slowly from lock to lock several times.
Lower the vehicle.
Start the engine.
Run the engine at idle for a few minutes.
Turn the steering wheel.
With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)
Repeat (*1) several times.
Stop the engine.
![]() |
Check for foaming or emulsification.
If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.
Check the fluid level.
| 11. INSPECT FOR POWER STEERING FLUID LEAK |
| 12. INSTALL NO. 1 ENGINE UNDER COVER |
![]() |
Hook the engine under cover to the vehicle body as shown in the illustration.
Install the 3 screws and 5 bolts.
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |