CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the Techstream to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 4.CHECK INDICATOR |
Check the indicator (Click here).
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC does not reoccur | A |
| DTC reoccurs | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
DATA LIST / ACTIVE TEST (Click here).
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|