Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab)

FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


B166605E01
  1. Align the vehicle's claws with the seat belt retractor positioning holes.

  1. Install the seat belt with the 2 bolts.

    HINT:
    First install bolt A, and then install bolt B.

    Torque:
    for bolt A:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }
    for bolt B:
    43 N*m{ 428 kgf*cm , 31 ft.*lbf }



    B166612
  1. Connect the pretensioner connector as shown in the illustration.



    B167428
  1. Insert the bolt and extension of the anti-rotation device through the quarter trim panel hole into the vehicle body.

  1. Install the seat belt's shoulder anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



    B165727
  1. Attach the 2 claws to close the seat belt anchor cover.



2. INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY


B165710
  1. Attach the 7 clips to install the quarter trim panel.



    B166849
  1. Twist the seat belt clockwise and install the seat belt anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    HINT:
    For the RH side, twist the seat belt counterclockwise.



    B165729
  1. Attach the 2 claws to install the cover.



3. INSTALL LUGGAGE COMPARTMENT BOX RH


B164748
  1. Install the luggage compartment box with the 4 clips.



4. INSTALL LUGGAGE COMPARTMENT BOX LH


B164747
  1. Attach the 3 claws to install the luggage compartment box.

  1. Install the 2 clips.



5. INSTALL UPPER BACK PANEL GARNISH


B164740
  1. Attach the 10 clips to install the upper back panel garnish.



6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP


7. INSTALL FRONT DOOR SCUFF PLATE


B165843
  1. Attach the 6 claws and 3 clips to install the front door scuff plate.



8. INSTALL FRONT SEAT ASSEMBLY
  1. for Manual Seat:
    Install the front seat (Click here).

  1. for Power Seat:
    Install the front seat (Click here).



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).