Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY (for Double Cab)

REAR SEAT OUTER BELT ASSEMBLY (for Double Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR SEAT ASSEMBLY
  1. Remove the rear seat (Click here).



2. REMOVE REAR DOOR SCUFF PLATE


B165842
  1. Detach the 6 claws and 2 clips, and remove the rear door scuff plate.



3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP


4. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY


B165830
  1. Detach the 2 claws and remove the cover.



    B165831
  1. Remove the bolt and seat belt anchor.



    B165832
  1. Detach the 6 clips and remove the quarter trim panel.



5. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY


B165711E05
  1. Using a screwdriver, detach the claw and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



    B165833
  1. Remove the 2 bolts.

  1. Detach the 4 clips.

  1. Pass the rear seat outer belt floor anchor through the quarter trim panel, and remove the front quarter trim panel.



6. REMOVE REAR SEAT OUTER BELT ASSEMBLY


B166738
  1. Remove the bolt and shoulder anchor.

  1. Remove the bolt and disconnect the seat belt's shoulder anchor.



    B166716
  1. Remove the 2 bolts and seat belt.