Home › ENGINE ยท 1UR-FE › COOLING › WATER PUMP

WATER PUMP > INSTALLATION

for Preparation Click here



1. INSTALL WATER PUMP ASSEMBLY


    A215872E01
  1. Install a new gasket and the water pump with the 8 bolts shown in the illustration.

    Torque:
    for bolt A:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }
    for bolt B:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }
    for bolt C:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. INSTALL WATER PUMP PULLEY
  1. Temporarily install the pulley with the 4 bolts.



    A210018E02
  1. Using SST, hold the pulley and tighten the 4 bolts.

    SST
    09960-10010   (09962-01000, 09963-01000)

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



3. INSTALL WATER INLET HOUSING
  1. Install a new gasket to the water pump.



    A215871
  1. Install the water inlet housing with the 3 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



4. CONNECT NO. 5 WATER BY-PASS HOSE


    A215870E01
  1. Connect the water by-pass hose.

    HINT:
    The direction of hose clamp is indicated in the illustration.



5. CONNECT NO. 8 WATER BY-PASS HOSE


    A215868E01
  1. Connect the water by-pass hose.

    HINT:
    The direction of hose clamp is indicated in the illustration.



6. INSTALL NO. 1 WATER BY-PASS HOSE


    A215866E01
  1. Install the water by-pass hose.

    HINT:
    The direction of hose clamp is indicated in the illustration.



7. INSTALL WATER BY-PASS PIPE (w/ Oil Cooler)


A215864E01
  1. Connect the 4 water hoses.

    HINT:
    Connect each hose so that the direction of each hose clamp is as indicated in the illustration.

  1. Install the water by-pass hose with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



8. CONNECT COOLER COMPRESSOR ASSEMBLY (w/ Oil Cooler)


E147759E01
  1. Install the cooler compressor and 2 stud bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Install the 2 bolts and 2 nuts.

    Torque:
    24.5 N*m{ 250 kgf*cm , 18 ft.*lbf }

    HINT:
    Tighten the bolts and nuts in the order shown in the illustration to install the cooler compressor.

  1. Connect the connector.



9. INSTALL FRONT FENDER APRON SEAL LH
  1. Install the fender apron seal with the 6 clips.



10. INSTALL WATER INLET SUB-ASSEMBLY WITH THERMOSTAT
  1. Install the water inlet with thermostat (Click here).



11. INSTALL FAN SHROUD
  1. Install the fan shroud (Click here).