Home › ENGINE ยท 1UR-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE FAN SHROUD
  1. Remove the fan shroud (Click here).



2. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT
  1. Remove the water inlet with thermostat (Click here).



3. REMOVE FRONT FENDER APRON SEAL LH
  1. Remove the 6 clips and fender apron seal.



4. DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Oil Cooler)


    E147759
  1. Disconnect the connector.

  1. Remove the 2 bolts and 2 nuts.

  1. Remove the 2 stud bolts and cooler compressor.



5. REMOVE WATER BY-PASS PIPE (w/ Oil Cooler)


A210013
  1. Remove the 2 bolts.

  1. Disconnect the 4 water hoses and remove the water by-pass pipe.



6. REMOVE NO. 1 WATER BY-PASS HOSE


    A215865
  1. Remove the water by-pass hose.



7. DISCONNECT NO. 8 WATER BY-PASS HOSE


    A215867
  1. Disconnect the water by-pass hose.



8. DISCONNECT NO. 5 WATER BY-PASS HOSE


    A215869
  1. Disconnect the water by-pass hose.



9. REMOVE WATER INLET HOUSING


    A215871
  1. Remove the 3 bolts and water inlet housing.

  1. Remove the gasket from the water pump.



10. REMOVE WATER PUMP PULLEY


    A210018E02
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-01000)

  1. Remove the 4 bolts and water pump pulley.



11. REMOVE WATER PUMP ASSEMBLY


    A215872
  1. Remove the 8 bolts, water pump and gasket.