DTC B2322 Front Passenger Side Door ECU Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2322 | No communication between the front power window regulator motor assembly RH and main body ECU (driver side junction block) for 10 seconds or more. |
|

| 1.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B2322 output reoccurs | A |
| DTC B2322 output does not reoccur | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - REGULATOR MOTOR RH) |
![]() |
Disconnect the J2 main body ECU (driver side junction block) connector.
Disconnect the M11 front power window regulator motor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J2-10 (LIN2) - M11-9 (LIN) | Always | Below 1 Ω |
| J2-10 (LIN2) or M11-9 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (REGULATOR MOTOR RH - BATTERY AND BODY GROUND) |
![]() |
Disconnect the M11 front power window regulator motor assembly RH connector.
Measure the resistance and voltage according to the value(s) in the tables below.
| Tester Connection | Condition | Specified Condition |
| M11-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| M11-2 (B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 5.REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH |
Temporarily replace the front power window regulator motor assembly RH with a new or normally functioning one (Click here).
Clear the DTC (Click here).
| NEXT | |
| 6.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B2322 output does not reoccur | A |
| DTC B2322 output reoccurs | B |
|
| ||||
| A | ||
| ||