AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU |

| 1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - RADIO RECEIVER) |
![]() |
Disconnect the J107 multi-media interface ECU connector.
Disconnect the K22 radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J107-2 (URO+) - K22-2 (CDR+) | Always | Below 1 Ω |
| J107-3 (URO-) - K22-3 (CDR-) | Always | Below 1 Ω |
| J107-4 (ULO+) - K22-4 (CDL+) | Always | Below 1 Ω |
| J107-5 (ULO-) - K22-5 (CDL-) | Always | Below 1 Ω |
| J107-1 (USD1) - Body ground | Always | 10 kΩ or higher |
| J107-2 (URO+) - Body ground | Always | 10 kΩ or higher |
| J107-3 (URO-) - Body ground | Always | 10 kΩ or higher |
| J107-4 (ULO+) - Body ground | Always | 10 kΩ or higher |
| J107-5 (ULO-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||