Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

DTC    U0208    Lost Communication with "Seat Control Module A"

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0208
No communication from front power seat control ECU with switch LH
  1. Power source circuit of front power seat control ECU and switch LH
  2. Front power seat control ECU and switch LH
  3. Front power seat control ECU and switch LH branch wire or connector

WIRING DIAGRAM


C158945E09


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any other switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


NEXT


2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NEXT


3.CHECK FOR OPEN IN CAN BUS WIRE (FRONT POWER SEAT CONTROL ECU AND SWITCH LH BRANCH WIRE)


    C159483E01
  1. Disconnect the Z10 front power seat control ECU and switch LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Z10-5 (CANH) - Z10-1 (CANL)
    Ignition switch OFF
    54 to 69 Ω



NG
REPAIR OR REPLACE FRONT POWER SEAT CONTROL ECU AND SWITCH LH BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


4.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT CONTROL ECU AND SWITCH LH - BATTERY AND BODY GROUND)
  1. Reconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.



    C159482E01
  1. Disconnect the Z9 front power seat control ECU and switch LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Z9-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Z9-5 (+B) - Body ground
    Always
    11 to 14 V
    Z10-8 (SYSB) - Body ground
    Always
    11 to 14 V
    Z10-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY (Click here)