DTC B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side) |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1446/46 | Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix servo motor |
|

| 1.READ VALUE USING TECHSTREAM (AIR MIX SERVO MOTOR TARGET PULSE (for Driver Side)) |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Air Mix Servo Targ Pulse (D) | Driver side air mix servo motor target pulse / Min.: 0, Max.: 255 | MAX. COLD: 5 (pulse) MAX. HOT: 104 (pulse) | - |
| Result | Proceed to |
| OK (Checking from the DTC) | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR MIX SERVO MOTOR (for Driver Side) |
Temporarily replace the air mix servo motor with a new one (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPAIR OR REPLACE AIR CONDITIONING HARNESS |
Repair or replace the air conditioning harness.
| NEXT | |
| 5.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC again (Click here).
|
| ||||
| OK | ||
| ||