ENGINE IMMOBILISER SYSTEM > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR LIGHT) |
Select the Active Test, use the Techstream to generate a command.
Check that the security indicator light operation is normal.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | ON/OFF | - |
|
| ||||
| OK | |
| 2.CHECK TRANSPONDER KEY ECU |
![]() |
Remove the transponder key ECU with the connector still connected (Click here).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J26-8 (IND) - Body ground | Engine immobiliser system is set | Alternating between 11 to 14 V and below 1 V |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - TRANSPONDER KEY ECU AND BODY GROUND) |
![]() |
Disconnect the K20 meter connector.
Disconnect the J26 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K20-17 (LP) - J26-8 (IND) | Always | Below 1 Ω |
| K20-12 (E) - Body ground | Always | Below 1 Ω |
| K20-17 (LP) - Body ground | Always | 10 kΩ higher |
|
| ||||
| OK | ||
| ||