FRONT SEAT SIDE AIRBAG ASSEMBLY (except Fold Down Seat Type) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat) |
Remove the front seat assembly LH (Click here).
| 4. REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Manual Seat) |
![]() |
Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.
![]() |
Remove the 2 screws and vertical adjuster handle.
| 5. REMOVE VERTICAL SEAT ADJUSTER KNOB LH (for 8 Way Manual Seat) |
![]() |
Remove the snap ring and vertical seat adjuster knob.
| 6. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat) |
![]() |
Lift the reclining adjuster release handle.
Using a screwdriver, detach the claw and remove the reclining adjuster release handle.
| 7. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat) |
![]() |
Remove the hog rings and rubber bands of the seatback cover from the seat frame.
![]() |
Remove the 2 screws.
Detach the 3 claws in the order shown in the illustration, and then remove the cushion shield.
w/ Lumbar Support Adjuster:
Disconnect the switch connector.
| 8. REMOVE INNER FRONT SEAT CUSHION SHIELD LH (for Manual Seat) |
![]() |
Remove the screw.
Detach the 3 claws in the order shown in the illustration, and then remove the cushion shield.
| 9. REMOVE FRONT SEAT HEADREST ASSEMBLY LH (for Manual Seat) |
| 10. REMOVE FRONT SEATBACK COVER WITH PAD LH (for Manual Seat) |
![]() |
Detach the hook.
![]() |
Remove the hog rings and seatback cover wires.
![]() |
Remove the nut and seatback cover bracket from the seat frame.
![]() |
Detach the 4 claws and remove the 2 headrest supports.
![]() |
Remove the hog rings and seatback cover with pad.
| 11. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat) |
Remove the front seat assembly LH (Click here).
| 12. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH (for Power Seat) |
![]() |
Apply protective tape around the cushion shield.
Using a screwdriver, detach the 2 claws and remove the knob.
| 13. REMOVE RECLINING POWER SEAT SWITCH KNOB LH (for Power Seat) |
![]() |
Using a screwdriver, detach the 2 claws and remove the knob.
| 14. REMOVE FRONT SEAT CUSHION SHIELD LH (for Power Seat) |
![]() |
Remove the hog rings and rubber bands of the seatback cover from the seat frame.
Remove the 2 screws.
![]() |
Remove the 3 screws.
Detach the 2 claws and remove the cushion shield.
Disconnect the switch connectors.
| 15. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Power Seat) |
Driver Side:
Disconnect the 2 connectors and detach the 4 clamps.
Passenger Side:
Disconnect the connector and detach the clamp.
![]() |
Remove the nut and front seat inner belt.
| 16. REMOVE INNER FRONT SEAT CUSHION SHIELD LH (for Power Seat) |
![]() |
Remove the screw.
Detach the 2 claws and clip, and then remove the cushion shield.
| 17. REMOVE FRONT SEATBACK COVER WITH PAD LH (for Power Seat) |
![]() |
Detach the hook.
![]() |
Remove the hog rings and seatback cover wires.
![]() |
Remove the nut and seatback cover bracket from the seat frame.
![]() |
Detach the 4 claws and remove the 2 headrest supports.
![]() |
Remove the hog rings and seatback cover with pad.
| 18. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Disconnect the 3 wire harness clamps from under the seat.
![]() |
Disconnect the 2 clamps.
Remove the 2 nuts and the front seat side airbag assembly.