STEERING PAD > INSTALLATION |
| 1. INSTALL STEERING PAD (w/ Steering Pad Switch) |
![]() |
Support the steering pad with one hand.
Connect the 2 connectors to the steering pad.
Confirm that the circumference groove of the screw fits in the screw case, and place the steering pad onto the steering wheel .
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 2. INSTALL STEERING PAD (w/o Steering Pad Switch) |
![]() |
Support the steering pad with one hand.
Connect the 2 connectors to the steering pad.
Confirm that the circumference groove of the screw fits in the screw case, and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 3. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 4. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
w/ Cruise Control:
Attach the 2 claws to install the cover.
![]() |
w/o Cruise Control:
Attach the 2 claws to install the cover.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. INSPECT STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Check that the horn sounds.
If the horn does not sound, inspect the horn system.
| 7. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).