CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type) > INSTALLATION |
| 1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
![]() |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the airbag sensor with the 3 bolts.
Check that there is no looseness in the installation parts of the center airbag sensor.
Connect the holder (with connectors).
Check that the waterproof sheet is properly set.
| 2. INSTALL FRONT CONSOLE BOX |
![]() |
Install the front console box with the 6 screws and 2 clips.
| 3. INSTALL REAR CONSOLE BOX ASSEMBLY |
![]() |
Install the rear console box with the 2 screws and 4 bolts.
Attach the 2 wire harness clamps.
| 4. INSTALL CONSOLE BOX CARPET |
| 5. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY |
![]() |
except Regular Cab:
Attach the 2 wire harness clamps and connect the connector.
Attach the 7 clips to install the end panel.
| 6. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY |
w/ Trailer Towing System:
Connect the connector.
Attach the 6 clips to install the console panel.
Install the clip.

| 7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Attach the 12 clips to install the console panel.
| 8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Install the shift lever knob and twist it in the direction indicated by the arrow.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).