Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type)

CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B161742
  1. Detach the 12 clips and remove the console panel.



5. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY
  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.



  1. w/ Trailer Towing System:
    Disconnect the connector


    B171298



6. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY


    B227980
  1. Using a moulding remover, detach the 7 clips and remove the end panel.

  1. except Regular Cab:
    Detach the 2 wire harness clamps and disconnect the connector.



7. REMOVE CONSOLE BOX CARPET


8. REMOVE REAR CONSOLE BOX ASSEMBLY


    B227981
  1. Remove the 2 screws.

  1. Detach the 2 wire harness clamps.

  1. Remove the 4 bolts and rear console box.



9. REMOVE FRONT CONSOLE BOX


    B161746
  1. Remove the 2 clips.

  1. Remove the 6 screws and front console box.



10. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


    B166503
  1. Disconnect the holder (with connectors).

  1. Remove the 3 bolts and airbag sensor.