Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG CUTOFF SWITCH

CURTAIN SHIELD AIRBAG CUTOFF SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)


B165843
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate.



4. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)


B165841
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate.



5. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



6. REMOVE INSTRUMENT SIDE PANEL LH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B226741
  1. Remove the bolt.

  1. Remove the 3 screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



8. REMOVE CURTAIN SHIELD AIRBAG CUTOFF SWITCH


    B166515
  1. Disconnect the connector.

  1. Detach the 2 claws and remove the switch.