Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE LOWER STEERING COLUMN COVER
  1. for Manual Tilt and Telescopic:

    1. Operate the tilt and telescopic lever to fully extend and lower the steering column.

  1. for Power Tilt and Telescopic:

    1. Turn the ignition switch ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.



    E146419
  1. While turning the steering wheel to the right and left, remove the 2 screws and lower steering column cover.

  1. Detach the 2 claws to remove the lower steering column cover.

    NOTICE:
    Do not damage the tilt and telescopic switch.



4. REMOVE UPPER STEERING COLUMN COVER


    E146420
  1. Detach the 4 clips.

  1. Detach the claw to remove the upper steering column cover.



5. REMOVE IGNITION KEY CYLINDER LIGHT


    E145067E01
  1. Disconnect the unlock warning switch connector.

  1. Detach the 2 claws.

  1. Disconnect the connector and remove the key cylinder light.