METER / GAUGE SYSTEM > Speedometer Malfunction |

| 1.CHECK CAN COMMUNICATION |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN communication DTC is not output | A |
| CAN communication DTC is output | B |
|
| ||||
| A | |
| 2.CHECK SFI SYSTEM (VEHICLE SPEED) |
Check for DTCs (Click here).
| Result | Proceed to |
| SFI system DTC is not output | A |
| SFI system (for 1GR-FE) DTC is output | B |
| SFI system (for 1UR-FE) DTC is output | C |
| SFI system (for 3UR-FE) DTC is output | D |
| SFI system (for 3UR-FBE) DTC is output | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (SPEEDOMETER) |
Operate the Techstream according to the display and select "Active Test" (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Speed Meter Operation | Speedometer | 0, 40, 80, 120, 160, 200, 240 or 280 | - |
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (VEHICLE SPEED) |
Operate the Techstream according to the display and select "Data List" (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed meter | Vehicle speed/Min.: 0 (0), Max.: 255 (158) | Almost same as actual speed (when driving) | Unit: km/h (mph) |
|
| ||||
| OK | ||
| ||
| 5.READ VALUE USING TECHSTREAM (WHEEL SPEED SENSOR) |
Operate the Techstream according to the display and select "Data List" (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| (FL/FR/RL/RR) Wheel Speed | Wheel speed sensor (FL/FR/RL/RR) reading/Min.: 0 (0), Max.: 326 (202) | Actual wheel speed | Similar speed as indicated on speedometer |
|
| ||||
| OK | ||
| ||