METER / GAUGE SYSTEM > Tachometer Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (TACHOMETER) |
Operate the Techstream according to the display and select "Active Test" (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Tachometer Operation | Tachometer | 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 | - |
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (TACHOMETER) |
Operate the Techstream according to the display and select "Active Test" (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Rpm | Engine speed/Min.: 0, Max.: 12750 | Idling: 700 to 800 | Unit: rpm |
|
| ||||
| OK | ||
| ||
| 4.READ VALUE USING TECHSTREAM (ENGINE SPEED) |
Operate the Techstream according to the display and select "Data List" (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Speed | Engine speed/Min.: 0, Max.: 16838.75 | Idling: 700 to 800 | Unit: rpm |
| Result | Proceed to |
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for 1UR-FE) | C |
| NG (for 3UR-FE) | D |
| NG (for 3UR-FBE) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||