Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Voltage Meter Malfunction

for Preparation Click here


DESCRIPTION

The voltmeter indicates the voltage applied to the IG+ terminal of the combination meter.

WIRING DIAGRAM


E146354E01


INSPECTION PROCEDURE

1.INSPECT FUSE (MET)
  1. Remove the MET fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    MET fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.PERFORM ACTIVE TEST USING TECHSTREAM (VOLTMETER)
  1. Operate the Techstream according to the display and select "Active Test" (Click here).

    OK:
    Needle indication is normal.


    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Volt Meter Operation
    Voltmeter
    0, 3, 6, 9, 12, 15 or 18
    Perform the test with the vehicle stopped and engine idling



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)
E146031E02
  1. Disconnect the J28 meter connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J28-40 (E1)
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J28-20 (IG+)
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)