Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning buzzer is installed in the accessory meter.

WIRING DIAGRAM


E146060E01


INSPECTION PROCEDURE

1.CHECK FUSE (ECU-IG No. 1)
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (ACCESSORY METER - BATTERY)


    E146329E01
  1. Disconnect the K20 meter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K20-23 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ACCESSORY METER - ECU)


    E146059E02
  1. Disconnect the J35 ECU connector.

  1. Disconnect the K20 meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J35-12 (BBZ) - K20-11 (BZ)
    Always
    Below 1 Ω
    J35-12 (BBZ) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE ACCESSORY METER
  1. Replace the accessory meter with a normally functioning or new accessory meter (Click here).

  1. Check that the accessory meter buzzer operates normally.

    OK:
    Accessory meter buzzer operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (ACCESSORY METER IS DEFECTIVE)