Home › BODY › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat)

LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    B167109
  1. Install the lumbar support adjuster with the 2 screws.

  1. Connect the lumbar support adjuster connector.



    B167105E02
  1. w/o Climate Control Seat System:

    1. Attach the 6 hooks to install the seatback spring.

    2. Install the 2 springs.



    B194042E02
  1. w/ Climate Control Seat System:

    1. Attach the 4 hooks to install the seatback spring.

    2. Install the 4 springs.



    3. B232376
    4. Attach the 2 clamps and connect the connector.



2. INSTALL FRONT SEATBACK COVER WITH PAD LH
  1. Install seatback cover with pad to the seatback frame.



    B165534E06
  1. Using hog ring pliers, install new hog rings to the seat frame.



    B165529
  1. Attach the 4 claws to install the 2 headrest supports.



    B165533
  1. Install the seatback cover bracket to the seat frame with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    CAUTION:
    After the seatback trim cover is assembled, make sure the side airbag strap is not twisted.

  1. Install the seatback cover wires.



    B167102E04
  1. Using hog ring pliers, install new hog rings to the seat frame.



    B167101E04
  1. Attach the hook.



    B167194
  1. w/ Seat Heater System or Climate Control Seat System:
    Connect the seat heater connector and attach the wire harness clamp.



3. INSTALL INNER FRONT SEAT CUSHION SHIELD LH


B166948
  1. Attach the 2 claws and clip to install the cushion shield.

  1. Install the screw.



4. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH


B166599E01
  1. Install the front seat inner belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt to overlap the protruding part of the front seat adjuster.

  1. Driver Side:

    1. Connect the 2 connectors and attach the 4 clamps.

  1. Passenger Side:
    Connect the connector and attach the clamp.



5. INSTALL FRONT SEAT CUSHION SHIELD LH


B166945
  1. Connect the switch connectors.

  1. Attach the 2 claws to install the cushion shield.

  1. Install the 3 screws.



    B166944E02
  1. Install the 2 screws.

  1. Using hog ring pliers, install the rubber band of the seatback cover to the seat frame with new hog rings.



6. INSTALL RECLINING POWER SEAT SWITCH KNOB LH


B167192
  1. Attach the 2 claws to install the knob.



7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH


B167193
  1. Attach the 2 claws to install the knob.



8. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the front seat assembly (Click here).