Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a display signal from the television display assembly to the navigation receiver assembly.

WIRING DIAGRAM


E145839E06


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - NAVIGATION RECEIVER)


    C227214E01
  1. Disconnect the W2 television display assembly connector.

  1. Disconnect the K24 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    W2-11 (NTSO) - K24-2 (VV+)
    Always
    Below 1 Ω
    W2-10 (SGN1) - K24-6 (VV-)
    W2-9 (SLD) - K24-6 (VV-)
    W2-11 (NTSO) - Body ground
    Always
    10 kΩ or higher
    W2-10 (SGN1) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TELEVISION DISPLAY ASSEMBLY (NTSO SIGNAL)


    E145842E03
  1. Using an oscilloscope, check that waveform.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    W2-11 (NTSO) - Body ground
    Tool Setting
    0.2 V/DIV., 10 μs/DIV.
    Condition
    DVD displayed on television display

    OK:
    Waveform is as shown in the illustration.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)