Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit is from the parking brake switch assembly to the navigation receiver assembly.

WIRING DIAGRAM


E231670E01


INSPECTION PROCEDURE

1.CHECK VEHICLE SIGNAL


    E235191E05
  1. Enter the "Function Check/Setting I" mode and select "Vehicle Signal" (Click here).

  1. Check that the display changes between ON and OFF according to the parking brake operation.

    OK:
    Parking Brake Position
    Display
    Applied
    ON
    Released
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    C159029E06
  1. Remove the parking brake switch assembly connector (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Parking brake switch ON (switch pin released)
    Below 1 Ω
    Parking brake switch OFF (switch pin pushed in)
    10 kΩ or higher

    Text in Illustration 
    *a
    Released
    *b
    Pushed in



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
  1. Disconnect the K6 navigation receiver assembly connector.

  1. Disconnect the A5 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K6-1 (PKB) - A5-1
    Always
    Below 1 Ω
    K6-1 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)