Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B226008
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the 3 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL LOWER INSTRUMENT PANEL


    B226759
  1. Attach the 2 claws.

  1. Install the panel with the bolt and screw.



3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B226758
  1. Attach the 2 guides.

  1. Attach the 4 claws and clip to install the panel.



4. INSTALL INSTRUMENT SIDE PANEL RH


    B229198
  1. Attach the 6 claws to install the side panel.



5. INSTALL COWL SIDE TRIM BOARD RH

HINT:
Use the same procedures described for the LH side.



6. INSTALL FRONT DOOR SCUFF PLATE RH (for Regular Cab)

HINT:
Use the same procedures described for the LH side.



7. INSTALL FRONT DOOR SCUFF PLATE RH (for Double Cab, CrewMax)

HINT:
Use the same procedures described for the LH side.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



9. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).