DTC CB-13 USB Over Current Detection |
| DTC Code | DTC Detection Condition | Trouble Area |
| CB-13 | "iPod" or USB device overcurrent malfunction |
|

| 1.REPLACE USB Device OR "iPod" |
Disconnect the USB device or "iPod" from the stereo jack adapter.
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter.
| NEXT | |
| 2.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 3.RECHECK FOR DTC |
Recheck for DTCs and check if the same DTC occurs again.
|
| ||||
| OK | ||
| ||
| 4.CHECK NO. 1 STEREO JACK ADAPTER ASSEMBLY |
![]() |
Disconnect the J100 No. 1 stereo jack adapter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J100-1 (UPI) - J100-4 (UJSG) | Always | 5 V |
| Result | Proceed to |
| OK (for Column Shift Type) | A |
| OK (for Floor Shift Type) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER) |
![]() |
Disconnect the J116 multi-media interface ECU connector.
Disconnect the J100 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J116-4 (UDO) - J100-4 (UJSG) | Always | Below 1 Ω |
| J116-1 (UESG) - J100-1 (UPI) | Always | Below 1 Ω |
| J116-4 (UDO) - Body ground | Always | 10 kΩ or higher |
| J116-1 (UESG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||