Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    CB-45    USB Communication Error

DTC    CB-46    iPod Control Error

DTC    CB-47    iPod Communication Error

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
CB-45
Communication error with USB device
  1. USB device
  2. Multi-media interface ECU
CB-46
"iPod" control software malfunction
  1. "iPod"
  2. Multi-media interface ECU
CB-47
Communication error with "iPod"

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the stereo jack adapter.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the stereo jack adapter.

HINT:
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.


NEXT


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

END (USB DEVICE OR "iPod" WAS DEFECTIVE)