Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > CD Sound Skips

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK DISC


    I100152
  1. Check that the disc is not deformed or cracked.

    OK:
    No deformation or cracks on the disc.



NG
CHANGE DISC
OK


2.CHECK DISC


    I100151
  1. Disc cleaning

    1. If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

      OK:
      Malfunction disappears.

      NOTICE:
      Do not use a conventional record cleaner or antistatic preservative.



NG
Go to step 3
OK

END (DISC IS DIRTY) 

3.REPLACE DISC WITH ANOTHER AND RECHECK
  1. Replace the disc with a known good one and check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
Go to step 4
OK

END (DISC IS DEFECTIVE) 

4.CHECK NAVIGATION RECEIVER ASSEMBLY
  1. Check that the navigation receiver assembly is properly installed

Result 
Result
Proceed to
OK (for Column Shift Type)
A
OK (for Floor Shift Type)
B
NG (for Column Shift Type)
C
NG (for Floor Shift Type)
D


B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REINSTALL NAVIGATION RECEIVER ASSEMBLY (Click here)

D
REINSTALL NAVIGATION RECEIVER ASSEMBLY (Click here)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)