DTC P0116 Engine Coolant Temperature Circuit Range / Performance Problem |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0116 | When either of following conditions met (2 trip detection logic):
|
|
| Related DTCs | P0116: Engine Coolant Temperature (ECT) sensor cold start monitor P0116: ECT sensor soak monitor |
| Required Sensors/Components (Main) | ECT sensor |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Once per driving cycle |
| Duration | -: Cold start monitor 10 seconds: Soak monitor |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0112, P0113 (Intake air temperature sensor) P0115, P0117, P0118 (Engine coolant temperature sensor) P0125 (Insufficient coolant temperature for closed loop fuel control) P0128 (Thermostat) |
| Battery voltage | 10.5 V or more |
| Time after engine start | 1 second or more |
| ECT at engine start | Less than 60°C (140°F) |
| Soak time | 0 seconds or more |
| Accumulated MAF | 5228 g or more |
| Fuel cut | OFF |
| Difference between ECT at engine start and IAT | Less than 40°C (104°F) |
| Monitor runs whenever following DTCs not present | P0112, P0113 (Intake air temperature sensor) P0115, P0117, P0118 (Engine coolant temperature sensor) P0125 (Insufficient coolant temperature for closed loop fuel control) P0128 (Thermostat) P2610 (Soak timer) |
| Battery voltage | 10.5 V or more |
| Engine | Running |
| Soak time | 5 hours or more |
| Either condition (a) or (b) met | - |
| (a) ECT | 60°C (140°F) or more |
| (b) Accumulated MAF | 10456 g or more |
| ECT sensor value change | Less than 5°C (41°F) |
| Difference between current ECT sensor value and previous ECT sensor value when engine stopped | Less than 5°C (41°F) [varies with ECT of last trip engine stop] |
| ECT | ECT sensor value changes in accordance with actual ECT |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| P0116 is output | A |
| P0116 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY |
Remove the water inlet with thermostat sub-assembly (Click here).
Measure the valve opening temperature of the water inlet with thermostat sub-assembly.
|
| ||||
| OK | ||
| ||